Doosan GC20SC-5 — Doosan GC20SC-5 User Manual

Maintenance section Inspect Battery System Replace Oxygen Sensor (G420F(E) Engine Only) 1. Clean battery outer surfaces with a mixture of baking soda and water. 2. Inspect battery outer surfaces for damage and replace as necessary. 3. Remove battery cable and clean, repair and/or replace as necessary. G420F(E) Engine When indicated by MIL, replace oxygen seasor on the exhaust manifold and oxygen sensor on muffler assembly. 1. Stop engine and wait until the exhaust pipe and exhaust pipe is cooled. 2. Disconnect the electrical connector of oxygen sensor 3. Remove oxygen sensor 4. Assemble new oxygen sensor Tightening torque : 45 N•m (32.5 lb•ft) 5.

Connect the electrical connector of oxygen sensor When assembling the filters, check the arrow mark on the filter surface. The arrow mark position is same as fuel flow direction. 142 WARNING