NOTE: The Mode Button must be pressed and released to shift modes. Approximately two seconds after the Mode Button is released, the digital gauge will return to full display. 11. Drive Select Indicator - Displays 4WD when selected by the drive select switch or when the differential lock is engaged. The display is blank when in 2WD. 4. Set/Reset Button - In conjunction with the Mode Button, sets and resets various displays on the digital gauge. Also used to shift from speedometer function to tachometer function on the speedometer/ tachometer gauge. 12. Speedometer - Indicates the approxi- mate vehicle speed in miles per hour (MPH) or kilometers per hour (km/h). NOTE:
To change MPH/km/h dis- play, press and release Mode But- ton (3) until the icon (MPH/km/h) appears; then press the Set/Reset Button (4) to change the display. 5. Fuel Level Indicator - Indicates approximate amount of gasoline in the gas tank. NOTE: When the bottom seg- ment flashes, approximately 3.5 L (0.92 U.S. gal.) of gasoline remains in the tank. 13. Right Turn Signal - Will be displayed when the right turn signal is selected. 14. Left Turn Signal - Will be displayed when the left turn signal is selected. 6. Low Oil Pressure - Will be displayed during self-test at start-up. It will not be displayed during normal opera- tion as oil pressure is not monitored on these models.
Condition Warning Display - Uses odome- ter/trip meter display of the LCD to warn of a system error condition requiring attention. A. Volt - The LCD will go blank except the word VOLT will flash on the LCD whenever a low voltage ( voltage (> 16 DC volts) is detected. When voltage returns to normal, the gauge must be reset by turning the ignition key to the OFF position and then to the ON position. 7. Odometer/Trip Meter - Odometer registers the total distance the vehi- cle has traveled. The trip meter can be reset and can be used to measure trip or trip legs. The odometer can- not be reset. NOTE:
To shift between the odometer (ODO) or trip meter (TRIP), press the Mode Button (3) to select the distance mode; then press the Set/Reset Button (4) to select the desired display. Hold the Set/Reset Button down to reset the trip meter. B. EFI - The LCD will go blank except the letters EFI will flash on the LCD whenever an elec- tronic fuel injection error is detected. After 30 seconds, the LCD will return to normal; how- ever, the letters EFI will continue to flash until the cause of the error is corrected. 8. Gear Position Indicator - Indicates which gearshift position is selected. R (reverse)/N (neutral)/L (low range)/H (high range) NOTE:
An E will be displayed if there is an error caused by a no- shift position signal. NOTE: Take the ATV to an autho- rized Arctic Cat ATV dealer to have the EFI error corrected and to have the ECU reset as soon as possible. Electric Fuel Pump An electric fuel pump is incorporated in the gas tank to deliver gasoline to the fuel injec- tor. The fuel pump is activated when the ignition switch is in the ON position. 9. High Beam Indicator - The High Beam icon will appear only when the headlights are on high beam. 10. Differential Lock Indicator - Dis- plays LOCK when the differential lock has been engaged. 40