Drive Axle Boots Maintenance Charging NOTE: Arctic Cat recommends the use of the CTEK XS 800 or the CTEK MXS 3600 for battery mainte- nance charging. Maintenance charging is required on all batteries not used for more than two weeks or as required by battery drain. 1. When charging a battery in the vehi- cle, be sure the ignition switch is in the OFF position. ACE-029A 2. Clean the battery terminals with a solution of baking soda and water. NOTE: The sealing strip should NOT be removed and NO fluid should be added. 3. Be sure the charger and battery are in a well-ventilated area. Be sure the charger is unplugged from the 240- volt electrical outlet. CF125A 1.
Inspect all drive axle boots for cracks, tears, or perforations. 4. Connect the red terminal lead from the charger to the positive terminal of the battery; then connect the black terminal lead of the charger to the negative terminal of the battery. NOTE: Optional battery charging adapters are available from your authorized Arctic Cat dealer to con- nect directly to your vehicle from the recommended chargers to simplify the maintenance charging process. Check with your authorized Arctic Cat dealer for proper installation of these charging adapter connectors. 2. If boot damage is present, contact an authorized Arctic Cat ATV dealer for service. Battery The battery is located under the seat.
After being in service, batteries require regular maintaining in order to deliver peak performance and maximum service life. The following procedures are recom- mended for cleaning, maintaining, and charging sealed batteries. Always read and follow instructions provided with battery chargers and battery products. NOTE: Refer to all warnings and cautions provided with the battery or battery maintainer/charger. 5. Plug the battery charger into a 240- volt electrical outlet. 6. If using the CTEK XS 800, there are no further buttons to push. If using the CTEK MXS 3600, press the Mode button (A) at the left of the charger until the Maintenance Charge Icon (B) at the bottom illu- minates.
The Normal Charge Indica- tor (C) should illuminate on the upper portion of the battery charger. Loss of battery charge may be caused by ambient temperature, ignition OFF current draw, corroded terminals, self discharge, frequent start/stops, and short engine run times. Frequent winch usage, snowplow- ing, extended low RPM operation, short trips, and high amperage accessory usage are also reasons for battery discharge. 50