3. Connect the red terminal lead from the charger to the positive terminal of the battery; then connect the black terminal lead of the charger to the negative terminal of the battery. 4. Plug the charger into a 240-volt electrical outlet. 5. By pushing the Mode button (A) on the left side of the charger, select the Normal Charge Icon (E). The Nor- mal Charge Indicator (C) should illuminate on the upper left portion of the charger. 800A 6. The battery will charge to 95% of its capacity at which time the Mainte- nance Charge Indicator (D) will illu- minate. NOTE:
For optimal charge and performance, leave the charger connected to the battery for a mini- mum 1 hour after the Maintenance Charge Indicator (D) illuminates. If the battery becomes hot to the touch, stop charging. Resume after it has cooled. 3600A NOTE: The maintainer/charger will charge the battery to 95% capacity at which time the Mainte- nance Charge Indicator (D) will illu- minate and the maintainer/charger will change to pulse/float mainte- nance. If the battery falls below 12.9 DC volts, the charger will automati- cally start again at the first step of the charge sequence. DIVISION II - OPERATION/ MAINTENANCE 8.
Once the battery has reached full charge, unplug the charger from the 240-volt electrical outlet. NOTE: If, after charging, the bat- tery does not perform to operator expectations, bring the battery to an authorized Arctic Cat dealer for further troubleshooting. NOTE: Not using a battery char- ger with the proper float mainte- nance will damage the battery if connected over extended periods. Charging Spark Plug The ATV comes equipped with a speci- fied spark plug. See the Specifications chart for the correct spark plug. A light brown insulator indicates that the plug is correct. A white or dark insulator indi- cates that the engine may need to be ser- viced.
Consult an authorized Arctic Cat ATV dealer if the plug insulator is not a light brown color. NOTE: Arctic Cat recommends the use of the CTEK XS 800 or the CTEK MXS 3600 for battery mainte- nance charging. 1. Be sure the battery and terminals have been cleaned with a baking soda and water solution. NOTE: The sealing strip should NOT be removed and NO fluid should be added. To help prevent cold weather fouling, make sure to thoroughly warm up the engine before operating. To maintain a hot, strong spark, keep the plug free of carbon. 2. Be sure the charger and battery are in a well-ventilated area. Be sure the charger is unplugged from the 240- volt electrical outlet.
Before removing the spark plug, be sure to clean the area around the spark plug. If you do not, dirt could enter engine when remov- ing or installing the spark plug. 51