Arctic Cat ATV 700 PS EFT/700 TRV PS EFT — Arctic Cat ATV 700 PS EFT/700 TRV PS EFT User Manual

Adjust the gap to 0.7-0.8 mm (0.028- 0.032 in.) for proper ignition. Use a wire- type feeler gauge to check the gap. Air Filter The air filter inside the air filter housing must be kept clean to provide good engine power and gas mileage. If the ATV is used under normal conditions, service the filter at the intervals specified in the Service Book- let. If operated in dusty, wet, or muddy con- ditions, inspect and service the filter more frequently. Use the following procedure to remove the filter and inspect and/or clean it. 0.7-0.8 mm (0.028-0.032 in.) Failure to inspect the air filter fre- quently if the ATV is used in dusty, wet, or muddy conditions can damage the engine.

CAUTION ATV-0052 When installing the spark plug, be sure to tighten it securely. A new spark plug should be tightened 1/2 turn once the washer contacts the cylinder head. A used spark plug should be tightened 1/8 - 1/4 turn once the washer contacts the cyl- inder head. Throttle Cable Adjustment To adjust the throttle cable free-play: 1. Raise the storage compartment cover; then slide the cover forward and off the compartment. Remove the storage compartment. 1. Loosen the jam nut from the throttle cable adjuster. 2. Slide the rubber boot away and turn the adjuster until the throttle lever has the proper free-play of 3-6 mm (1/8-1/4 in.). CD669 ATV-0047 3.

Tighten the knurled nut against the throttle cable adjuster securely; then slide the rubber boot over the adjuster. CD671 2. Remove the wing nuts securing the air filter housing cover and the air filter/frame assembly. 3. Remove the foam element from the frame making sure not to tear the element. 52