Arctic Cat ATV 700 PS EFT/700 TRV PS EFT — Arctic Cat ATV 700 PS EFT/700 TRV PS EFT User Manual

NOTE: The bulb portion of the headlight is fragile. HANDLE WITH CARE. When replacing the head- light bulb, do not touch the glass portion of the bulb. If the glass is touched, it must be cleaned with a dry cloth before installing. Skin oil residue on the bulb will shorten the life of the bulb. 3. To install the bulb, push in and turn clockwise. 4. Insert the socket into the housing and rotate it clockwise. To replace the front turn signal light/front position light bulb, use the following pro- cedure. 1. Rotate the socket counterclockwise and remove it from the housing. ! WARNING Do not attempt to remove the bulb when it is hot. Severe injury may result. 2.

To remove the bulb from the socket, pull it straight out of the socket. To replace the headlight bulb, use the fol- lowing procedure. 3. To install the bulb, push it straight into the socket. 1. Remove the rubber boot from the back of the headlight housing; then remove the three-wire connector from the bulb. 4. Insert the socket into the housing and rotate it clockwise. Fuses The fuses are located in a power distribu- tion module under the seat. If there is any type of electrical system failure, always 2. Release the two ends of the spring clip from the headlight housing making sure not to bend or deform the clip; then remove the bulb from the housing. 3.

Install the new bulb into the hous- ing; then secure with the spring clip. 4. Connect the three-wire connector to the bulb; then install the rubber boot. CAUTION When replacing the headlight bulb, be careful not to touch the glass portion of the bulb. Grasp the new bulb with a clean cloth. To replace the license plate bulb, use the following procedure. 2411-213 1. Remove the two screws and remove the lens. CAUTION 2. Pull out the bulb. Always replace a blown fuse with a fuse of the same type and rating. If the new fuse blows after a short period of use, consult an authorized Arctic Cat ATV dealer immediately. 3. Install the new bulb by pushing it in. 4. Install the lens.

Tighten the two screws securely. Storage Compartment/ Tools A basic tool kit is provided with the ATV. Maintain the tool kit with the ATV at all times. The tool kit is located under the seat. To replace the turn signal light - rear/tail- light/brakelight bulb, use the following procedure. 1. Rotate the socket counterclockwise and remove it from the housing. 2. To remove the bulb from the socket, push in and rotate counterclockwise. The storage compartment is above the engine in front of the seat. 55 check the fuses first. NOTE: To remove the fuse, com- press the locking tabs on either side of the fuse cover and lift off; then remove and replace the fuse.

DIVISION II - OPERATION/ MAINTENANCE Power Steering