Arctic Cat ATV 700 PS EFT/700 TRV PS EFT — Arctic Cat ATV 700 PS EFT/700 TRV PS EFT User Manual

Tire Tread Condition Tubeless Tire Repair The use of worn-out tires on an ATV is very dangerous. A tire is considered to be worn out when the depth of the tread is less than 4 mm (5/32 in.). Be sure to replace the tires before reaching this min- imum specification. Should a leak or flat tire occur due to a puncture, the tire may be repaired using a plug-type repair. If the damage is from a cut or if the puncture cannot be repaired using a plug, the tire must be replaced. When operating the ATV in areas where transportation or service facilities are not readily available, it is strongly recom- mended to carry a plug-type repair kit and a tire pump along. Wheels 1.

Park the ATV on level ground and engage the parking brake lock. 2. Loosen the lug nuts on the wheel to be removed. 732-649A 3. Elevate the ATV by placing a jack under the axle. ! WARNING The use of worn-out tires is danger- ous and can increase the risk of an accident. 4. Remove the lug nuts. 5. Remove the wheel. Tire Replacement 6. Install the wheel and install the lug nuts. The ATV has low-pressure tubeless tires. Air is sealed by the contact surfaces of the inner wheel rim and the tire bead. If either the inner wheel rim or tire bead is damaged, air may leak. Be extremely careful not to damage these areas when replacing tires. 7.

Tighten the nuts in a crisscross pat- tern to 4.4 kg-m (32 ft-lb). 8. Remove the jack. ! WARNING Failure to tighten the lug nuts to specified torque value can be haz- ardous. If the nuts are not properly tightened, the wheel can come off causing an accident and possible severe injury. It is very important to use the proper tools when repairing or replacing tires to prevent damage to the tire bead or wheel rims. If proper tools and related items are not available, have this maintenance per- formed by an authorized Arctic Cat ATV dealer or a qualified tire repair station. Light Bulb Replacement The wattage rating of each bulb is shown in the chart.

When replacing a burned bulb, always use the same wattage rating. CAUTION When breaking the tire bead loose from the wheel, be extremely careful not to damage the inner wheel surface or the tire bead. ! WARNING Use only Arctic Cat approved tires when replacing tires. Failure to do so could result in unstable ATV operation. 54 Headlight 12V/35W/35W Taillight/Brakelight 12V/5W/21W License Plate Light 12V/5W Turn Signal - Front 12V/27W Turn Signal - Rear 12V/10W Position Light - Front 12V/5W CAUTION Use only specified bulbs indicated in the chart as replacement bulbs.