Scania — Renewing the seal in the front cover

Engine Ch 1 page 101 Renewing the seal in the front cover 1. Remove the fan ring and the fan. Thermostatic fan: Store it upright (vertical). 2. Remove the belt(s), crankshaft damper and belt pulley. 3. Remove the driver bolts and withdraw the driver. Mind the sealing surface. 4. Pull or prise off the seal in the cover. Take care to avoid damaging the sealing surface in the cover. 5. Wipe the sealing surface in the cover clean. Note: The crankshaft seal must be fitted dry and must not be lubricated. The sleeve in the seal should be left in place until the seal is fitted. Tool 524615 with crankshaft seal 6.

Place the new seal on tool 8421 and press it in place by tightening the diametrically opposite bolts alternately. The seal is correctly fitted when the tool comes up against the cover. 7. Remove the tool by screwing the bolts into the threaded holes. 8. Wipe the driver sealing surface clean. Fit a new seal on the end surface of the driver and push the driver onto the spacing sleeve on the end of the crankshaft. 9. Bolt the driver to the crankshaft flange and tighten the flange bolts to 135 Nm. 10. Bolt the crankshaft damper and possibly the belt pulley to the hub and tighten to 110 Nm. 524615 11. Fit the belt(s), fan ring and fan. SHOP MANUAL MT41 - 12.2004