Engine Ch 1 page 102 Crankshaft damper 1 1.Oscillation damper The power impulses from the connecting rods give rise to torsional oscillation in the crankshaft. These oscillations are severest at certain engine speeds which vary with the design of the engine, how it is loaded, etc. Torsional oscillation is characterised as follows: The flywheel (at the “rear” end of the crankshaft) rotates at an almost constant speed throughout each revolution of the crankshaft. Relative to the flywheel, the rotational speed of the front end of the crankshaft will increase and decrease several times during each revolution.
To reduce the amplitude of the oscillation, a crankshaft damper is attached to the front end of the crank shaft. A ring of steel is incorporated in the circular and completely enclosed housing of the crankshaft damper. The housing is bolted onto the crankshaft. There is a heavy oil between the housing and ring which damps the relative movement between the two. The oscillation at the front of the crankshaft is damped by the ring striving to rotate with even speed. The crankshaft damper has numerous belt grooves for a “Multigroove V-belt”, see also previous pages SHOP MANUAL MT41 - 12.2004