Scania — Intermediate gear

Engine Ch 1 page 105 Intermediate gear Intermediate gear Removal - The timing gear has two intermediate gears. - One for the camshaft and pump drive and one for driving the compressor. - Both these gears should be removed in the same manner. 1. Turn the crankshaft so that cylinder number 1 is close to TDC. Use tool 8405 and ratchet handle on the flywheel starter ring gear. 8405 2. Remove the flywheel as described in the section Removing the flywheel. 3. Remove the flywheel housing as described in Removing the flywheel housing. 4. Manufacture a thread block according to the sketch. 5. The shaft on which the gear is located has a groove. Fit puller 8414, slide hammer 8049 and the thread block.

Loosen the gear and shaft. Note: After removing the intermediate gear, neither the camshaft or the crankshaft must be rotated. This may cause pistons and valves to collide and be damaged . 8414 8049 SHOP MANUAL MT41 - 12.2004