Engine Ch 1 page 106 1. Press the shaft out of the bearing. 2. Press the bearing inner race shell from the shaft and remove the retaining ring. 3. Place the removed bearing inner race in the bearing and press out the bearing using drift 8413 4. Press a new bearing onto the shaft journal using drift 8413. Note: Do not press on the outer race. 8133 5. Press the bearing and shaft journal into the intermediate gear using drift 8133 6. Fit the snap ring. 7. Press the spacing ring onto the shaft journal. Ensure that the shaft journal is on the press table. SHOP MANUAL MT41 - 12.2004