Engine Ch 1 page 107 Fitting 1. Check that cylinder number 1 is close to TDC. The markings on the camshaft gear and crankshaft gear must point towards the centre of the intermediate gear. 2. Lubricate the bearing surfaces. 3. Fit the intermediate gear against the camshaft gear and the crankshaft gear so that the markings point towards each other. 4. Fit the second intermediate gear. 5. Tighten the bolts on the intermediate gears to 50 Nm + 60°. 6. Fit the flywheel housing as described in the section Fitting the flywheel housing. 7. Fit the flywheel as described in the section Fitting the flywheel. SHOP MANUAL MT41 - 12.2004