Scania — Camshaft gear

Engine Ch 1 page 108 Camshaft gear Removal 1. Turn the crankshaft so that cylinder number 1 is close to TDC. Use tool 8405 and ratchet handle on the flywheel starter ring gear. 2. Remove the flywheel as described in the section Removing the flywheel. 8405 3. Remove the flywheel housing as described in the section Removing the flywheel housing. 4. Remove the intermediate gear. Note: After removing the intermediate gear, neither the camshaft nor the crankshaft must be rotated. This may cause pistons and valves to collide and be damaged. 5. Remove the camshaft gear. Fitting 1. Fit the camshaft gear and torque tighten the bolts to 63 Nm. 2.

Fit the intermediate gear as described in Intermediate gear, fitting. 3. Fit the flywheel housing as described in the section Fitting the flywheel housing. 4. Fit the flywheel as described in the section Fitting the flywheel. SHOP MANUAL MT41 - 12.2004