Scania — Removal

Engine Ch 1 page 120 - When regrinding, stated undersizes must be complied with. Suitable bearings are available for these sizes. - Refer to the next page for the diameters required for different undersizes. - It is important that the fillet radius of the journals is correct. - After grinding the journals, the oil hole connections to the bearing surfaces should be rounded off and polished. Cylinder block Reconditioning Heat arising from the main bearings seizing and rotating in the cylinder block will change the properties of the material in the cylinder block. These cylinder blocks must be discarded.

If the main bearing seizes but does not rotate in the cylinder block, the cylinder block can be overhauled. The main bearing seats must comply with the demands on roundness given in the table. Machining out-of-round main bearing seats is something we do not recommend. 1. Measure the diameter at four different positions as illustrated. The diameter must be measured with the main bearing caps tightened and without main bearings. 2. Check the dimensions with those in the table. Minimum Maximum Maximum permitted permitted permitted diameter diameter difference* 112.200 mm 112.222 mm 0.016 mm *) Maximum permitted difference between the largest and smallest diameter on the same main bearing seat.

SHOP MANUAL MT41 - 12.2004