Scania — Removal

Engine Ch 1 page 119 Removal 1. Remove the crankshaft gear as described in Removing the crankshaft gear. 2. Remove the fan drive at the front end of the crankshaft as described in Belt transmission, Renewing the seal in the front cover. 3. Remove the oil sump, oil suction pipe with strainer and the oil pump. 4. Remove the pistons and connecting rods as described in Removing connecting rods and pistons. 5. Remove the crankshaft bearing caps and main bearings. Note: The main bearings and bearing caps are marked and must be refitted in the same place. 6. Lift out the crankshaft. Checking and grinding - Measure the crankshaft journals.

Use a micrometer to measure two diameters at right angles to each other. - If either of these diameters is lower than the minimum indicated limit, regrinding of the crankshaft should be considered. - Consideration must also be given to oil pressure, which is in turn affected by such things as main bearing and crankshaft bearing wear. SHOP MANUAL MT41 - 12.2004