Scania — Crankshaft

Engine Ch 1 page 118 Crankshaft Each compression stroke ”brakes” the crankshaft and each com­ bustion stroke attempts to increase the speed of rotation of the crankshaft. The pistons and connecting rods change their direction of travel twice during each rotation of the crankshaft. This exposes the crankshaft to numerous power pulses during each revolution. The material is of major importance for the useful life of the crank­ shaft. Its design and surface treat­ment also help to extend its life - for instance, the surface quality of the shaft journals is an impor­ tant factor in providing protection against fatigue failure.

The bearing surfaces on the crankshaft are hard­ened to a depth which allows them to be ground several times. Only the bearing surfaces are hardened as it is important to retain the toughness of the material in other parts. The bearing shells of the main and big-end bear­ings consist of three layers. An outer layer or backing of steel, an interlayer of lead-bronze and, nearest the crankshaft, an overlay consisting of a mixture of lead and indium or lead, tin and cop­per. The in­ nermost layer is usually worn away during the course of engine utilization. Thrust washers are used for endways location of the crankshaft at the rear main bearing.

These thrust washers are available in different thick­nesses so that the crankshaft can be adjusted to the correct clearance. The thrust washers have the same types of layer as the big-end bearing shells. SHOP MANUAL MT41 - 12.2004