Engine Ch 1 page 117 7. Fit the timing gear plate on the engine block. Tighten the bolts to 63 Nm. 8. Fit the intermediate gear as described in Intermediate gear, fitting. 9. Ensure that the markings on the camshaft gear point towards the centre of the intermediate gear. 10. Fit the camshaft gear and torque tighten the bolts to 63 Nm. 11. Fit the flywheel housing as described in Fitting the flywheel housing. 12. Fit the flywheel as described in Fitting the flywheel. Checking camshaft setting 1. Set the crankshaft to TDC after the compression stroke on cylinder number one. 2. Put two dial gauges against the valve spring thrust washers. 3.
Adjust the rocker arms to remove the free play and then adjust them further so that both valves are open 0.1 mm. 4. Zero both the dial gauges. 5. Turn the crankshaft one revolution in its direction of rotation until TDC position is again achieved. 6. Read off both dial gauges and compare with the values given below: - Intake valve lifting height 0.37-1.47 - Exhaust valve lifting height 0.16-1.16 SHOP MANUAL MT41 - 12.2004