Scania — Replacement of camshaft bearing

Engine Ch 1 page 116 Fitting 1. Fit the camshaft. Take care not to damage the cams and bearings. 2. Lubricate with engine oil and fit the valve tappets in the same places as they were before removal. Tighten the banjo bolts to 32 Nm. 3. Fit the camshaft covers. 4. Fit the guide flange bolts. 5. Remove all old sealing compound on the sealing surfaces of the timing gear casing and timing gear plate. Clean off any oil and grease using an alcohol based cleaning agent. Note: The sealing surfaces must be absolutely clean and free from grease. Do not touch the surfaces after degreasing. 6. Apply the sealing agent (512565) to the timing gear casing with the special nozzle.

The width of the bead should be between 0.8 and 1.2 mm. Follow the pattern as illustrated. Important! Ensure that you apply sealing agent inside the screwholes, but without allowing sealing agent into the crankcase. The sealing agent may block channels and nozzles. This is particularly important to bear in mind around oil ways, where the flow of oil to the air compressor or injection pump can be blocked. Important! Assembly must be completed within 25 minutes of starting to apply the sealing agent. SHOP MANUAL MT41 - 12.2004