Engine Ch 1 page 115 16. Remove the press drift by detaching flange nut 8 and pushing in the threaded stem. Note: The seats for camshaft bearings 2, 4 and 6 have two oil ducts. The others only have the lower one. 17. Check that the bearing oil hole is opposite the cylinder block oil ducts. Extraction and pressing of bearing number 2. 18. Repeat the procedure for the remaining bearings. 19. Clean the sealing surface, take a new gasket and fit the cover for the camshaft at the front of the engine. 20. Refit the camshaft according to the section Fitting the Camshaft. Then perform a check on the camshaft setting. Check measurement of bearing number 2 SHOP MANUAL MT41 - 12.2004