Scania — Replacement of camshaft bearing

Engine Ch 1 page 114 Note: The new bearing is in the correct position before the old bearing is completely released. The new bearing has the correct position when the distance from the front edge of the cylinder block to the front edge of the press drift has a permitted value according to the table. By -12 mm it means that the drift should protrude 12 mm out of the block. Table for correctly located camshaft bearing Camshaft bearing no. Distance (mm) 1 -12 to -14 2 150 to 152 3 314 to 316 4 478 to 480 5 642 to 644 Contol measurement of bearing number 1 6 806 to 808 7 970 to 972 14.

Press in the new bearing at the same time as pressing out the old bearing with hydraulic cylinder 8036 and hydraulic pump 8037. Check that the bearing is correctly positioned by measuring. 15. Carefully knock with a plastic hammer to release the old bearing. SHOP MANUAL MT41 - 12.2004