Scania — Replacement of camshaft bearing

Engine Ch 1 page 113 10. Hang a new bearing on the stem at the front of the engine. 11. Place the press drift on the threaded stem and place the bearing on the drift. Note: The recess in the bearing joint must be turned towards the flange on the press drifts. Secure the bearing on the drift by placing the spring-loaded ball in an oil way. The bearing is correctly located on the drift when the ball and a marking hole are centred on the bearing oil hole. The bearing is correctly located on the drift when the ball and a marking hole are oppo­site the bearing’s oil hole 12. Clean around the bearing contact surface. Note:

The marking on the drift must be uppermost and vertical so that the oil hole in the bearing will be central to the oil ways. 13. Hold the press drift with the new bearing against the old. Secure the threaded stem between the press drift and hydraulic cylinder 8036 by tightening flange nut 8 on the stem. 8036 8 SHOP MANUAL MT41 - 12.2004