Engine Ch 1 page 112 6. Take the threaded stem and insert the end with flange nut number 1 from the rear edge of the engine past the rearmost bearing seat. Insert it further through the bearing seats and the new bearings until flange nut 1 protrudes from the front of the engine. 7. Screw the flange part of tool 8467 securely onto hydraulic cylinder 8036 with two M6x12 bolts. Press together cylinder 8036 if not already in neutral position. 8. Screw the flange securely to the hydraulic cylinder at the rear of the engine with two of M10x25. 9. Screw on flange nut 8, from tool 8467, onto the threaded stem. 8036 8 SHOP MANUAL MT41 - 12.2004