Engine Ch 1 page 39 Overview of flash codes for coordinator Continued next page SHOP MANUAL MT41 - 12.2004 Code Description of fault Cause Action Note 11 Incorrect signals from the accelerator pedal sensor. The flash code is registered when the voltage from the accelerator pedal sensor is outside the setting range. Check the accelerator pedal sensor, connectors and cables. See also fault codes for the ECU control unit. 12 Incorrect signals from the cruise control switches. The flash code is registered when the voltage from the cruise control switches is not within the correct range. Check the cruise control switches, connectors and cables.
When there are fault codes, the cruise control will perate. 13 No communication with the engine. The flash code is registered when communication from ECU (S6) is cut off. Check CAN connectors and cables. When this fault occurs, the diagnostics lamp for ECU (S6) also comes on. 14 Short-circuit in the tachometer signal circuit. The flash code is registered when there is a short circuit between the output signal and earth or supply. The flash code is registered after 10 seconds. Check the instrument panel, connectors and cables. 15 Faulty atmospheric pressure sensor. The signal from the integrated sensor is outside the range. Renew the coordinator. See also fault codes for the ECU control unit.
The signal is not always required. Check with Moxy service. 16 The signals from the brake pedal switches do not agree. The flash code is registered after 5 minutes. Check the brake pedal switches, connectors and cables. See also fault codes for the ECU control unit. 17 Short circuit in the engine temperature gauge signal circuit. The flash code is registered when there is a short circuit between the output signal and supply. The flash code is registered after 10 seconds. Check the instrument panel, connectors and cables. If there is a fault the gauge will display a low temperature. 18 Short-circuit in the oil pressure gauge signal circuit.
The flash code is registered when there is a short-circuit between the output signal and supply. The flash code is registered after 10 seconds. Check the instrument panel, connectors and cables. If there is a fault the gauge will display a high pressure. 19 Short-circuit in the oil pressure lamp signal circuit. The flash code is registered when there is a short-circuit between the output signal and supply. The flash code is registered after 10 seconds. Check the instrument panel, connectors and cables. If there is a fault the lamp will not come on 21 Different versions of the communications protocol between the coordinator and EMS.
ECU does not have the same version of the communication protocol as the coordinator. Replace the coordinator with a matching unit.