Scania — Removing the ECU wiring

Engine Ch 1 page 44 Work description: 1 Make sure that the inlet pipe between the turbocharger and the air cleaner has been removed. 2 Fit the cable ducts. Schematic illustrations of the location of the cable ducts and their components are shown below 1 Cylinder 1–6 2 Coolant temperature sensor 3 Engine speed sensor 1 on flywheel 4 Engine speed sensor 2 on flywheel 5 Connector to control unit 6 Charge air pressure and temperature sensor 7 Oil pressure sensor 3 Run the cables to the unit injectors. Check that you have run the right cable to each unit injector by testing the cables with a multimeter as shown in the tables.

Cylinder Connector Pin 1 B2 1 and 6 2 B2 2 and 7 3 B2 4 and 9 4 A1 1 and 6 5 A1 2 and 7 6 A1 4 and 9 SHOP MANUAL MT41 - 12.2004