Scania — Removing the ECU wiring

Engine Ch 1 page 45 4 Press the cables into the groove in the lower rocker cover. See the illustration about Fitting the wiring. Note: Take care when tightening the cable connection screws on the unit injector. If a screw breaks, the unit injector must be replaced. 5 Secure the cables to the unit injectors by tightening the screws. Use torque screwdriver 512562 and tighten the screws to 2.0 +/- 0.2 Nm. 107 519 (6- 7- 8- Other type of Scania engine) 512562 9 Fit the oil pressure sensor and its clamps. 10 Fit the coolant temperature sensor and its clamps. 11 Fit the charge air sensor and its clamps. Note: Handle the engine speed sensors with care.

They are magnetic and are sensitive to impacts. 12 Fit the auxiliary engine speed sensor and its clamps. 13 Fit the main engine speed sensor and its clamps. 14 Connect ECOM to the engine and check the unit injectors by activating them. Check also that the values from the sensors are correct. 15 Plug the connectors into the control unit. 16 Fit the upper rocker covers and tighten the screws to 18 ± 3 Nm. 17 Fit the inlet pipe between the turbocharger and the air cleaner. 18 Top up with coolant in accordance with the SHOP MANUAL MT41 - 12.2004