Engine Ch 1 page 65 WARNING! ! Take care when carrying out the adjustment if the dimension is well outside the adjustment dimension. The spring is pre-tensioned and can cause personal injury if it is released. 512263 PDE31 512263 PDE32 512264 (Tier3) See note previous side. 1. Position setting tool 512263 or 512264 with the metal plate around the injector spring. 2. Finely adjust dimension A by simultaneously using a finger to sense that the small piston 2 is level with the flat upper surface of the tool. It is possible to sense differences of less than a tenth of a millimetre. 512263 3. If tool 512263 (or 512264 (Tier3) is not available:
Measure the distance between plane a and the top of the valve spring collar using a digital sliding caliper. Adjust the rocker posi tion by means of the adjusting screw until the dimension is 66.9 +/- 0.1 mm. 4. Tighten the lock nut to 39 Nm. 5. See on the section Testing & Adjusting: Checking/adjusting the injector rockers. SHOP MANUAL MT41 - 12.2004