Scania — Adjusting unit injectors

Engine Ch 1 page 64 IMPORTANT! Use torque screwdriver 512562 to avoid the risk of shearing off the screws. 512263 The entire unit injector must be renewed if the screws shear off. 9 Refit the upper rocker cover and torque tighten the bolts to 18 Nm. 10 Close the bleed nipple and tighten the banjo screw. 11 Fill and bleed the fuel system. Refer to Bleeding the fuel system. Adjusting unit injectors Important! The PDE31 unit injector is adjusted using setting tool 512263 or a digital sliding caliper. This adjustment is important because an incorrectly positioned unit injector may result in poor performance and possible breakdown.

Screw on the rocker arm adjusting screw 1 while measuring the distance between plane a and the top of the valve spring collar using a digital sliding caliper. NOTE ! Machine 810001-81108: Dimension A = PDE31: 66.9 +/- 0.1 mm Dimension B = PDE31: 36.5 mm Machine 810109 (Tier 3) - Dimension A = PDE32: 69.9 +/- 0.1 mm Dimension B = PDE32: 38,5 mm Tightening torques Lock nut on rocker arm: 39 Nm SHOP MANUAL MT41 - 12.2004