Scania — Fitting the piston and connecting rod

Engine Ch 1 page 90 Fitting the piston and connecting rod 1. Lubricate the piston, piston rings, cylinder liner and piston ring compressor with engine oil. 2. Remove the protection on the connecting rod journal and lubricate the journal. 3. Turn the piston rings so that the ring gaps are evenly distributed round the piston. 4. Fit the upper connecting rod bearing shell to the connecting rod and lubricate the bearing surface. 5. For engines with a scraper ring in the liner: Fit assembly tool 8409 instead of the scraper ring in the liner. 6. Carefully insert the connecting rod and piston so that the arrow mark on the piston points forward. 7.

Clamp piston ring compressor 8224 round the piston and push the piston down into the cylinder past the assembly tool. 8224 8. Remove the assembly tool and press in the scraper ring. Be careful to press it in straight so that it does not tilt. 9. For engines without a scraper ring in the liner: Insert the connecting rod and piston. On aluminium pistons the arrow mark on the piston should point forward. 8409 10. Clamp piston ring compressor 98 212 round the piston and push the piston down into the cylinder. SHOP MANUAL MT41 - 12.2004