Scania — Fitting the piston and connecting rod

Engine Ch 1 page 91 11. Fit the lower connecting rod bearing shell into the cap and lubricate the bearing surface. Fit the cap. Check that the connecting rod and cap have the same marking and that they are opposite each other. 12. Lubricate the bolts, fit them and tighten to 20 Nm + 90°. Check that the pistons nozzles are in perfect condition and fully open. If necessary, blow clean with compressed air. 13. Fit the piston cooling nozzle and tighten the banjo bolts to 23 Nm. Note: The piston cooling nozzle must not be damaged. The oil jet must hit the piston precisely. If it does not, the piston will become too warm resulting in engine breakdown.

Damaged nozzles must not be re-aligned, renew them instead. 14. Fit the oil sump and tighten the bolts to 30 Nm. 15. Fit the cylinder head. Tighten the cylinder head bolts as described in the section Cylinder head. SHOP MANUAL MT41 - 12.2004