Group 170 Preventive Maintenance Clutch Bearing and Cross Shaft The Volvo Clutch Release Bearing is sealed for life and does not need lubrication. However, the cross shaft must still be lubricated. Vendor clutch cross shafts and release bearings need to be lubricated. The cross shaft bearings are remotely lu- bricated by a hose. The grease fitting is located on the right side of the bell housing. Grease the release bearing but do not overgrease. Driveshafts When greasing a driveshaft U-joint, it is very important that grease comes out of each of the four bearings. If grease does not come out of a seal, move the shaft from side to side.
If a U-joint cannot be fully greased, note it on the form for further inspection. CAUTION An ungreased U-joint bearing will fail after a short time. If vehicle is equipped with a PTO that has a driveshaft, lubricate its U-joints. Volvo T-Ride 1 Remove the pressure relief valve located at A and install a grease fitting. 2 Remove the grease fitting at B 3 Fill with grease through A fitting until grease oozes out of B. 4 Install the grease fitting at B and fill it with grease until it oozes out around the entire seal (See arrow). 5 Remove the grease fitting at A and reinstall the pressure relief valve. It is important that the bearing is completely filled with grease.
This becomes very important if vehicle operates in wet areas. If operating in places where driving through water, lubricate daily to force water out of bearing area. 39