Group 170 Preventive Maintenance Slack Adjusters Note: For further information refer to literature in Func- tion Group 5. There is one grease fitting per slack adjuster. Fill with grease until old grease is forced out past the splined center and adjustment pawl area, and only uncontami- nated grease is visible. Front Spring Pins Note: For further information refer to literature in Func- tion Group 7. 1 Raise the front end of the truck up with a jack. 2 Place jack stands underneath the frame rails on both sides to relieve the suspension of any weight. Lower the jack so that the front axle hangs free.
3 Place jack stands underneath the frame rails on both sides to relieve the suspension of any weight. Lower the jack so that the front axle hangs free. 4 Note: Volvo only uses Chevron Grease EP #2. Then thoroughly grease through the grease fitting until the lubricant emerges past the bushing seals, cleaning out all contaminants. 5 After letting the truck down, grease the entire spring and bushing area again to ensure complete lubrica- tion coverage. 38