Group 170 Preventive Maintenance Steering Linkage Note: Greasable drag links are also available as an op- tion. 1 Lubricate the Steering shaft and drag link. 2 Lubricated the tie rod. TRW steering gears have a seal at the sector shaft that needs greasing with a hand gun every 4 months or more often if the weather and road conditions are severe. Sheppard steering gears have seals at input shaft and at the sector shaft that need greasing with a hand gun ev- ery 4 months or more often if the weather and road conditions are severe. No axial movement is allowable when 100 lbs. of hand pressure is applied. Use hand pressure only, do not check using pliers, wrenches or any other tools.
For all VHD Axle Back models, the steering shaft U- joints should be inspected to see that the plastic caps are intact. Complete this inspection every 4 months. A shorter inspection period interval may be required if the vehicle is operated under severe driving conditions. For VHD Axle Forward models, grease the steering shaft U-joints every 4 months. A shorter maintenance interval may be required if the vehicle is operated under severe driving conditions. Brake Cams Note: Meritor systems have special brake lubrication requirements. Refer to proper literature in Function Group 5. There is one grease fitting on each cam for front and rear wheel brakes.
Fill with grease until old grease is forced out past the end seal and only uncontaminated grease is visible. Note: Parking brake should be released so grease can penetrate properly throughout the brake cam. 37