Group 170 Preventive Maintenance Oil Filters Before working on a vehicle, set the parking brakes, place the transmission in neutral, and block the wheels. Failure to do so can result in unexpected vehicle movement and can cause serious personal in- jury or death. CAUTION Use only the engine manufacturer’s oil filter for re- placement. Use of an oil filter not built to specification could result in severe damage to bearings, crankshaft, etc. as a result of unfiltered oil entering the lubrication system. D12 Oil Filters Note: Always dispose of oil according to Federal and lo- cal regulations.
Used oil disposed of inappropriately can contaminate nature, waterways, community drinking wa- ter, and kills wildlife. Install new filters as follows: Coat the filter gasket with oil. Install the filter and turn it by hand until the gasket makes contact with the sealing surface. Then turn the filter an additional 3/4 turn. Oil Level Check Note: Do not let the oil level drop below the lower mark- ing on the dipstick. Do not overfill so the level is above the upper marking on the dipstick. D7 Oil Filters 1 Full-flow Filter 2 Bypass Filter Wait five minutes after shutting off the engine before checking the oil level. This gives the oil time to drain back to the oil pan. 43