Group 170 Preventive Maintenance The instruments and engine control units, are always included in the system. Other included control units de- pend on the vehicle variant, legal requirements, and the vehicle specifications. The control units are: Driver information display Instrument Cluster Vehicle Control Unit Engine Control Unit ABS Control Unit EBS Control Unit Air Suspension Control Unit Retarder Control Unit Load Indicator Control Unit SRS (Airbag) Control Unit Anti-Theft Control Unit Ensure the engine is switched off during the service check and the starter key is in the drive position (I).
The control lever on the right-hand side of the wheel is used to communicate and display any fault codes on the instrument’s driver information display. 1 Read any fault codes by using the control lever and display. These fault codes are saved in the vehicle’s control units. 2 Write down any fault codes displayed and then cor- rect the faults. 3 After correction, clear the fault codes. Note: Fault codes can also be traced using a diagnostic program run through a PC. Note: Refer to pertinent VCADS Pro Tool documentation. 56 20 Check for Fault Codes in the Vehicle Elec- tronic Control Unit