volvo — Volvo Trucks Service Manual Group 177-500

Group 170 Preventive Maintenance Note: For further information refer to literature in Func- tion Group 2. WARNING Do not remove the cap from the coolant surge tank while the engine and radiator are still hot. Scalding fluid and steam may be blown out by pressure if the cap is removed while the engine and radiator are hot. Note: This check is also considered Noise Emissions Control Maintenance, which is required maintenance for any Volvo vehicle. For further information on Noise Emis- sions refer to “Noise Emissions” page 6. Perform the Check of the Radiator, Hoses and Pipes as follows: 1 Check the front area of the radiator package for dirt and debris that hinders the air flow.

2 Clean the radiator package with compressed air or water pressure, blowing or pushing from the inside out. Note: Air pressure should not exceed 2 bar (30 psi) for the radiator and charge air cooler cores. Note: If there is damage to the cooling fins, straighten them out so air can flow freely. 3 Check for fluid leaks on or around the engine. Note: Inspect the mating surfaces, auxiliary compo- nent attaching areas and hookup, hoses and pipes. 4 Pump up pressure in the relief valve, with the heater controls open, to .75 bar (11 psi). Leave under pres- sure for five to ten minutes. Look for leaks, wear, cracking and distortion on hoses and tubing. 5 Check the hose clamps for tightness. Note:

For further information refer to literature in Func- tion Group 2. To complete a check of the engine and engine driven Power Take-Off complete the following: 1 Check that the engine does not leak oil or coolant. 2 Check that the fittings, flanges and hose connec- tions are tight. 3 Check that hoses or pipes are not chaffed or are cracked. 4 Check that the PTO or lines do not leak oil. 70 39 Check Radiator, Hoses and Pipes 40 Check Engine and Engine Driven Power Take-Off for Leaks