Group 170 Preventive Maintenance For further information refer to literature in Function Group 2. Ensure that the engine cannot be started while work- ing around the fan area. Failure to do so may result in serious personal injury or death. Note: This check is also considered Noise Emissions Control Maintenance, which is required maintenance for any Volvo vehicle. For further information on Noise Emis- sions refer to “Noise Emissions” page 6. Perform the Check of the Hubs and Pulleys as follows: 1 Inspect fan blades for any damage. 2 Ensure there is enough clearance between the fan blade tips and the fan ring in the shroud. Note:
The minimum clearance is 3 mm (0.12 in.) at any point around the fan ring. 3 Loosen the belts and rotate the fan hub assembly. Check for roughness and binding in the bearings. Check that the end play does not exceed 1.5 mm (1/16 in.). 4 Check fan clutch for lining wear or air leaks. Lubri- cate fan hub, if applicable. 5 Inspect the idler pulley for cracks. 6 Check for bearing roughness and binding. 7 Inspect the belt driven water pump for bearing wob- ble and any evidence of leakage. 8 Check the radiator package mounts. 9 Inspect rubber cushions for wear. 10 Inspect fan shroud rubber molding and all fasteners for wear and tightness.
69 38 Check Radiator Fan, Fan Shroud and Fan Ring with Rubber Seal