MAN — Man Series 40 Engine Operator's Guide

HOW-TO SECTION I. How to Drain and Flush the Cooling System To avoid injury from the expulsion of hot coolant, never remove the cooling system pressure cap while the engine is at operating temperature. Remove the cap slowly to relieve pressure. Wear adequate protective clothing (face shield or safety goggles, rubber gloves, apron, and boots). 1. Coolant Filter Gasket 3. Oil Cooler 2. Filter Header Figure 30 Installing Coolant Filter 1. With the engine cool, slowly loosen and remove the pressure cap from the radiator or deaeration tank. Place a suitable container under the radiator and drain the previous solution from the engine and radiator.

Dispose of the coolant in an environmentally friendly manner, according to state and/or federal (EPA) recommendations. 5. Tighten filter until gasket makes full contact with the header, then tighten one additional full turn. 6. Inspect the coolant level in the radiator or deaeration tank and top off with required coolant, if necessary. Replace the pressure cap and tighten securely. 7. Open the manual shutoff valve by turning counter-clockwise. In the open position, the handle will be parallel with the filter and pointing rearward. 2. Refill the cooling system with clean, soft water and a good cooling system cleaning compound, such as those listed in Table 54 in the Specifications section.

If the engine is warm, fill slowly to prevent the rapid cooling and distortion of the metal castings. 106 All information subject to change without notice. (Rev. May 2004) DDC-SVC-MAN-0057 0305 Copyright © 2003 DETROIT DIESEL CORPORATION