MAN — Man Series 40 Engine Operator's Guide

SERIES 40 ENGINE OPERATOR'S GUIDE H. How to Replace the Coolant Filter filter/strap wrench. See Figure 29. The coolant filter is installed on a header mounted at the rear of the gear case just above the oil cooler . Replace the coolant filter as follows: To avoid injury from the expulsion of hot coolant, never remove the cooling system pressure cap while the engine is at operating temperature. Remove the cap slowly to relieve pressure. Wear adequate protective clothing (face shield or safety goggles, rubber gloves, apron, and boots). 1. Coolant Filter 2. Coolant Filter Header Figure 29 Removing Coolant Filter 4.

Lubricate the new coolant filter gasket (1) with clean engine oil and install onto the header (2). See Figure 30. 1. With the engine at ambient temperature and cool to the touch, carefully remove the radiator or deaeration tank pressure cap to relieve pressure in the cooling system. 2. Close the manual shutoff valve on the coolant filter header by turning handle clockwise. In the closed position, the handle will be pointing straight up. 3. Loosen and remove the coolant filter by turning counter-clockwise using a All information subject to change without notice. (Rev. May 2004) 105 DDC-SVC-MAN-0057 0305 Copyright © 2003 DETROIT DIESEL CORPORATION