MAN — Man Series 40 Engine Operator's Guide

ENGINE STORAGE 3. Wash or steam clean the exterior of the engine to remove the rust preventive, if previously applied. Do not wash or apply steam to electrical components. Do not use plastic sheeting for outdoor storage. Plastic is fine for indoor storage. When used outdoors, however, enough moisture can condense on the inside of the plastic to rust ferrous metal surfaces and pit aluminum surfaces. If a unit is stored outside for any extended period of time, severe corrosion damage can result. NOTICE: 4. Remove the rust preventive from the flywheel. Flush any soluble oil rust inhibitor (if used) in the cooling system. 5.

Remove the paper strips from between the pulleys and serpentine drive belt or reinstall the drive belt, if previously removed. The stored engine should be inspected periodically. If there are any indications of rust or corrosion, corrective steps must be taken to prevent damage to the engine parts. Perform a complete inspection at the end of one year and apply additional treatment as required. 6. Fill the crankcase to the proper level with the required grade of lubricating oil. Use a pressure lubricator to insure all bearings and rocker shafts are lubricated. 7. Fill the fuel tank with the required fuel. Prime the fuel system. Restoring an Engine to Service after Extended Storage 8.

Close all drain cocks and fill the engine cooling system with clean, soft water and required inhibitors. If the engine is to be exposed to freezing temperatures, install genuine Detroit Diesel Power Cool antifreeze or an equivalent ethylene glycol-base or propylene glycol-base antifreeze solution which provides required freeze, boil over, and inhibitor protection. Refer to section G. How to Select Coolant. If an engine has been in extended storage, prepare it for service as follows: 1. Remove the covers and tape from all the openings of the engine, fuel tank and electrical equipment. Do not overlook the turbocharger air and exhaust outlets and the valve cover/intake manifold openings. 2.

Remove the plugs from the inlet and outlet fuel lines and reconnect the lines to their proper positions. 120 All information subject to change without notice. (Rev. May 2004) DDC-SVC-MAN-0057 0305 Copyright © 2003 DETROIT DIESEL CORPORATION