SERIES 40 ENGINE OPERATOR'S GUIDE 9. Install and connect the battery. Make sure the average specific gravity of the battery is 1.260 or higher. Charge the battery, if necessary. Preparations for Starting the Engine the First Time . 10. Service the air cleaner, if required. Diesel engine exhaust and some of its constituents are known to the State of California to cause cancer, birth defects, and other reproductive harm. 11. Transmission: Follow the manufacturer's recommendations covering the return of the transmission to service. 12. Power Take-Off: If equipped, follow the manufacturer's recommendations covering the return of the power take-off to service.
Always start and operate an engine in a well ventilated area. If operating an engine in an enclosed area, vent the exhaust to the outside. 13. Turbocharger: [a] Remove the tape or covers from the turbocharger air and exhaust outlet connections and the valve cover/intake manifold opening. Reconnect piping as required. Do not modify or tamper with the exhaust system or emission control system. 15. After all preparations are completed, start the engine. [b] Remove the oil inlet tube assembly from the turbocharger center bearing housing. Prelube bearings by pouring approximately five (5) ounces of clean lubricating oil into the opening.
Reinstall the oil inlet pipe using a new gasket, and torque inlet pipe flange bolts to specifications. NOTE: The small amount of rust preventive which remains in the fuel system will cause smoky exhaust for a few minutes. NOTE: Before subjecting the engine to a load or high speed, allow it to reach normal operating temperature. Then monitor the electronic control system diagnostic data link for trouble codes. 14. Refer to section Lubrication System Checks in section All information subject to change without notice. (Rev. May 2004) 121 DDC-SVC-MAN-0057 0305 Copyright © 2003 DETROIT DIESEL CORPORATION