OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS Preparations for Starting the Engine the First Time When preparing to start a new or newly overhauled engine which has been in storage, perform all of the operations listed below. Failure to follow these instructions may result in serious engine damage. Before a routine start, see the “Daily” checks for your engine. Refer to section MAINTENANCE SCHEDULES. To avoid injury when working near or on an operating engine, remove loose items of clothing, jewelry, tie back or contain long hair that could be caught in any moving part causing injury. Cooling System Checks 1.
Make sure all drain cocks in the cooling system are installed (drain cocks are often removed for shipping) and are closed tightly. Diesel engine exhaust and some of its constituents are known to the State of California to cause cancer, birth defects, and other reproductive harm. 2. Remove the radiator pressure control cap and fill with genuine Detroit Diesel Power Cool antifreeze or an equivalent quality ethylene glycol or propylene glycol-base antifreeze solution in the required concentration. In extremely hot environments, properly inhibited water may be used in the summer. Keep the coolant level at the bottom of the filler neck to allow for expansion of the coolant.
For more detailed recommendations, Always start and operate an engine in a well ventilated area. If operating an engine in an enclosed area, vent the exhaust to the outside. Do not modify or tamper with the exhaust system or emission control system. 18 All information subject to change without notice. (Rev. May 2004) DDC-SVC-MAN-0057 0305 Copyright © 2003 DETROIT DIESEL CORPORATION