MAN — Man Series 40 Engine Operator's Guide

SERIES 40 ENGINE OPERATOR'S GUIDE refer to section G. How to Select Coolant in this guide. rocker cover should be removed and clean lubricating oil should be poured over the rocker arms. The oil should be the same weight and viscosity as that used in the crankcase. After pre-lubricating, replace rocker cover and add additional oil to bring the level to the proper mark on the dipstick. See Figure 8. NOTE: Entrapped air must be purged after filling the cooling system. To do this, allow the engine to warm up with the pressure cap removed. With the transmission in neutral, increase engine speed above 1,000 rpm and add coolant to the radiator as required. 3.

Check to make sure the front of the radiator and air-to-air charge cooler are unblocked and free of debris. Lubrication System Checks Figure 8 Check Lube Oil Level Before Starting The lubricating oil film on the rotating parts and bearings of a new or newly overhauled engine, or one which has been in storage for six months or more, may be insufficient when the engine is started for the first time. NOTE: The current oil level gage is identified by the words “Operating Range” and separated by a cross-hatched area. When using this dipstick, keep the oil level within the cross-hatched area. NOTICE: Insufficient lubrication at startup can cause serious damage to engine components. NOTE:

The former oil level gage has the word above the upper gage line and the word below the lower gage line. When using this dipstick, maintain the oil level between the and gage lines. To insure an immediate flow of oil to all bearing surfaces at initial engine startup, the engine lubrication system should be charged with a commercially available pressure pre-lubricator. If this is impractical, All information subject to change without notice. (Rev. May 2004) 19 DDC-SVC-MAN-0057 0305 Copyright © 2003 DETROIT DIESEL CORPORATION