SERIES 40 ENGINE OPERATOR'S GUIDE NOTICE: NOTICE: Starting an engine taken out of storage or one recently overhauled without first priming the fuel system will result in an overload condition that can damage the injector tips. To avoid injector tip damage, the fuel system must be primed before initial engine startup. Failure to disconnect the CMP (camshaft position sensor) before priming the engine may allow the engine to start during priming, which could result in severe engine damage. 1. Disconnect the CMP (camshaft position sensor) to prevent the engine from starting. If the engine is equipped with a fuel/water separator, drain off any water that has accumulated.
Water in fuel can seriously affect engine performance and may cause engine damage. Detroit Diesel recommends installation of a fuel/water separator wherever water contamination is a concern. 2. Using the manual priming pump on the fuel filter header, fill the system with clean fuel until the primer pump is hard to depress. 3. Crank the engine three times for 15 seconds each. Reapply the primer pump after each crank cycle. If previously disconnected, reconnect charge air cooler piping to valve cover/intake manifold. 4. Once the primer pump is hard to depress (usually three crank and hand prime cycles), reconnect the CMP.
To insure prompt starting, even running and avoid injector tip damage, the fuel system must be primed before initial engine start. Use this procedure: Other Checks NOTE: Authorized Detroit Diesel service outlets are properly equipped and have the trained technicians to perform this service. Check the hydrometer of maintenance-free batteries for charge. See Figure 9. All information subject to change without notice. (Rev. May 2004) 21 DDC-SVC-MAN-0057 0305 Copyright © 2003 DETROIT DIESEL CORPORATION