OPERATING INSTRUCTIONS Starting the Engine Before starting the engine the first time, refer to section Preparations for Starting the Engine the First Time in the Operating Instructions section and perform the operations listed. To avoid injury from flames, explosion, and toxicants when using ether, the following precautions must be taken: Figure 9 Check of Maintenance-Free Batteries If lead-acid or low-maintenance batteries are used, make sure battery electrolyte level is normal. Do not smoke when servicing ether system. Work in well-ventilated area. Do not work near open flames, pilot flames (gas or oil heaters), or sparks.
Make sure cable connections to the storage batteries are clean and tight. Check the turbocharger for signs of oil or exhaust leaks. Leaks should be corrected before starting the engine. Do not weld or carry an open flame near the ether system if you smell ether or otherwise suspect a leak. Check engine mounting bolts for tightness. Bolts should be retightened, if necessary. Make sure the transmission is filled to the proper level with the fluid recommended by the gear manufacturer. Do not overfill. The engine may require the use of a cold weather starting aid if the ambient temperature is below 40 °F (4 °C).
Check drive belts to make sure they are in good condition (not cracked, torn, worn or glazed). 22 All information subject to change without notice. (Rev. May 2004) DDC-SVC-MAN-0057 0305 Copyright © 2003 DETROIT DIESEL CORPORATION