MAN — Man Series 40 Engine Operator's Guide

SERIES 40 ENGINE OPERATOR'S GUIDE Engine Diagnostic Button Initial Engine Start The engine diagnostic button, located on the vehicle dashboard, is used to read faults detected by the ECM (electronic control module). The ECM will flash the CEL (check engine light) to warn of problems with the engine, oil, or coolant and indicates which faults have been detected. Diesel engine exhaust and some of its constituents are known to the State of California to cause cancer, birth defects, and other reproductive harm. Depress and hold the engine diagnostic button. Turn the ignition switch to the ON position and then release the engine diagnostic button. DO NOT START THE ENGINE.

The ECM will begin the self-test to check the sensor output circuits. If a fault is detected, the CEL will flash repeatedly, signaling the action fault code. Additional information on the engine diagnostic button is available in the Series 40 Troubleshooting Manual, 6SE241, available from authorized Detroit Diesel distributors. Always start and operate an engine in a well ventilated area. If operating an engine in an enclosed area, vent the exhaust to the outside. Do not modify or tamper with the exhaust system or emission control system. Electric Starter Start an engine equipped with an electric starting motor as follows: 1. Set the parking brake and place the transmission in NEUTRAL.

If an automatic transmission, place it in PARK or NEUTRAL. 2. Depress the clutch pedal, if equipped. Do not depress the accelerator pedal. All information subject to change without notice. (Rev. May 2004) 23 DDC-SVC-MAN-0057 0305 Copyright © 2003 DETROIT DIESEL CORPORATION