MAN — Man Series 40 Engine Operator's Guide

OPERATING INSTRUCTIONS to bring the pressure up to at least the recommended minimum for starting. To prevent serious starting motor damage, do not press the starter switch again after the engine has started. NOTICE: 2. With foot OFF the foot pedal, turn the ignition key to the start position and press and hold the starter button until the engine starts. 3. With foot off of the accelerator pedal, turn the ignition key to the START position and crank the engine. If the vehicle has push button starting, PRESS and HOLD the starter button. NOTE: If the engine fails to start after four attempts or if it starts and stops immediately, an inspection should be made to determine the cause. 4.

As soon as the engine starts, release the key or starter button, if applicable. Emergency Jump Starting NOTE: If the engine fails to start within 15 seconds, release the starter switch and allow the starter to cool for 15 seconds before trying again. If the engine fails to start after four attempts or if it starts and then stops immediately, an inspection should be made to determine the cause. To avoid injury from battery explosion when jump starting the engine, do not attach the cable end to the negative terminal of the disabled battery.

Air Starter – Because of the limited volume of most compressed air storage tanks and the relatively short duration of the cranking cycle, it is important to make sure the engine is ready to start before activating the air starter. Start an engine equipped with an air starter as follows: The Series 40 engine ECM (electronic control module) operates on either 12 or 24 volts. When jump starting an engine, do not exceed 18 volts for a 12–volt system or 32 volts for a 24–volt system. 1. Check the pressure in the air storage tank. If necessary, add air 24 All information subject to change without notice. (Rev. May 2004) DDC-SVC-MAN-0057 0305 Copyright © 2003 DETROIT DIESEL CORPORATION