MAN — Man Series 40 Engine Operator's Guide

SERIES 40 ENGINE OPERATOR'S GUIDE in this guide. Check the lube oil level at the start of each day and top off, if necessary. fuel/water separator, if equipped. Fill the fuel tank with required fuel to prevent condensation. Refer to section D. How to Select Fuel Oil in this guide. 5. At temperatures between 10 °F (–12 °C ) and 20 °F (–7 °C), DDC recommends using an ether-start kit and block heater. An on/off fan is also recommended. 4. Keep the external surfaces of the engine, radiator and accessories clean to avoid dirt buildup, which could lead to engine overheating. 6. At temperatures below 20 °F (–7 °C), an ether-start kit, coolant heater and oil pan heater are required.

Contact an authorized Detroit Diesel distributor about special cold weather equipment and precautions. Extended Idling Periods Avoid extended idling, especially at low engine speeds. The low idle speed for Series 40 vehicle engines is 700 rpm, while the low idle for construction/industrial engines is normally 800 rpm. If idling for long periods is necessary, use the optional electronic fast idle feature . Diesel engine efficiency is improved when cylinder temperatures remain high. Hot Weather Operation Observe the following instructions before operating the engine in hot weather. 1. Ensure the battery has the proper amount of electrolyte in each cell, if not a maintenance–free battery.

Top off cells with distilled water, or as per manufacturer's instructions. If cylinder temperatures are too low, the following may occur: 1. Unburned fuel, which has the dark-colored appearance of lubricating oil, may seep from the exhaust manifold gaskets and vehicle exhaust system connections. This seepage is commonly called exhaust “slobber.” 2. Fill the cooling system with required coolant. Periodically check level and top off, if necessary. Refer to section G. How to Select Coolant in this guide. 2. Cylinder temperature will be too low to allow complete combustion and unburned fuel will wash lubricating oil from the 3.

At the end of each day's operation, allow the engine to cool and then drain the water from the All information subject to change without notice. (Rev. May 2004) 29 DDC-SVC-MAN-0057 0305 Copyright © 2003 DETROIT DIESEL CORPORATION