OPERATING INSTRUCTIONS cylinder liners. The unburned fuel will be carried into the lubricating oil, causing fuel dilution. The cycle described above will continue until one or a combination of any of the following occurs: 3. Carbon deposits will form on fuel injector tips, causing nozzle plugging. Engine load is greater than 25%. Brake pedal is applied or brake switch fault is detected. 4. Carbon deposits will form on the turbine wheel of the turbocharger, reducing turbocharger efficiency. Clutch pedal is depressed or clutch pedal switch fault is detected (manual transmission). A CAP (cold ambient protection) system has been added to the ECMs used on vehicles.
This software aids in engine warm-up and helps maintain optimum engine heat during extended idling periods. Shift selector is moved from neutral to forward or reverse range (automatic transmission). PTO switch, also used for electronic hand throttle, is turned on. After five (5) minutes of idle time with the intake air temperature below 32 °F (0 °C), the CAP will slowly ramp up the engine idle speed to 900 rpm (engines with automatic transmissions) or 1400 rpm (engines with manual transmissions). Engine speed will increase or decrease to an rpm that will maintain a coolant temperature of 160 °F (71 °C). Accelerator pedal is depressed or accelerator pedal sensor fault is detected.
Timed idle shutdown is enabled. CTO (coolant temperature sensor) fault is detected. AIT (ambient air intake temperature) sensor fault is detected. NOTE: The lower CAP rpm limit for engines with automatic transmissions minimizes the possibility of vehicle lurch, should the operator place the shift lever in gear without first applying the service brakes to lower the idle speed to 700 rpm. 30 All information subject to change without notice. (Rev. May 2004) DDC-SVC-MAN-0057 0305 Copyright © 2003 DETROIT DIESEL CORPORATION