SERIES 40 ELECTRONIC CONTROL SYSTEM * Indicates WARN Lamp on When Fault Set Table 3 Series 40 Diagnostic Flash Codes (continued) 34 All information subject to change without notice. (Rev. May 2004) DDC-SVC-MAN-0057 0305 Copyright © 2003 DETROIT DIESEL CORPORATION Flash Code Circuit Description 311* EOT Engine Oil Temp. Signal Out of Range LOW 312* EOT Engine Oil Temp. Signal Out of Range HIGH 313 EOP** Engine Oil Press. Below Warning Level 314 EOP** Engine Oil Press. Below Critical Level 315* — Engine Speed Above Warning Level 316 — Engine Coolant Temp. Unable to Reach Commanded Set Point 321 ECT** Engine Coolant Temp. Above Warning Level 322 ECT** Engine Coolant Temp.
Above Critical Level 323 ECL Engine Coolant Below Warning / Critical Level 324 ECT Idle Shutdown Timer Enabled Engine Shutdown 325 ECT “Power Reduced, Matched to Cooling System Performance” 331* IPR Injection Control Press. Above System Working Range 332* ICP Injection Control Press. Above Spec with Engine Off 333* IPR Injection Control Press. Above/Below Desired Level 334 IPR SYS _ ICP Unable to Achieve Setpoint in Time (Poor Performance) 335 IPR SYS _ ICP Unable to Build Pressure During Cranking 336 HGE — 421 – 426 INJ High Side to Low Side Open (Cyl. Number Indicated) 431 – 436 INJ High Side Shorted to Low Side (Cyl. Number Indicated) 451 – 456 INJ High Side Shorted to Ground or V Bat.
(Cyl. Number Indicated)