SERIES 40 ENGINE OPERATOR'S GUIDE if possible. Replace any battery that fails to hold a charge. Periodically check battery connections for corrosion and tightness. If necessary, remove connections and wire brush any corrosion from terminals and cable ends. Replace damaged wiring. Item Drive Belt Inspect the serpentine drive belt after every oil change. Replace belt every 100,000 miles (160,000 km) on vehicle engines or every 2,000 hours on construction/industrial and stationary engines. Replace earlier if belt shows signs of excessive wear or damage.
Figure 14 Check of Maintenance-Free Batteries Maintain the electrolyte level according to the battery manufacturer's recommendations, but do not overfill. Overfilling can cause poor battery performance or early failure. Always replace the drive belt with the quality belt specified for your engine to ensure the belt will be neither too tight nor too loose. A belt that is too tight imposes extra loads on the crankshaft, water pump, alternator and fan hub bearings, shortening both belt and bearing life. A loose belt will slip and may cause damage to accessory components. Keep the terminal side of the battery clean. When necessary, wash with a solution of baking soda and water.
Rinse with fresh water. Do not allow the soda solution to enter the cells. Inspect the cables, clamps and hold-down brackets regularly. Clean and reapply a light coating of petroleum jelly when needed. Have corroded or damaged parts replaced. Before installing the drive belt, check the torque on the alternator and bracket mounting bolts. Retighten as required. The drive belt idler pulley should also be inspected whenever the belt is removed. Refer to Item 26 – Idler Pulley. If the engine is to be out of service for more than 30 days, remove the batteries and store in a cool, dry place. Keep batteries fully charged, All information subject to change without notice. (Rev.
May 2004) 61 DDC-SVC-MAN-0057 0305 Copyright © 2003 DETROIT DIESEL CORPORATION